| |
|
RSS Feed - WebSphere MQ Support
|
RSS Feed - Message Broker Support
|
  |
|
| ADOPTMCA and ADOPTMCACHK parms for Unix |
« View previous topic :: View next topic » |
| Author |
Message
|
| Glen Shubert |
 Posted: Wed Aug 22, 2001 2:07 pm Post subject: |
 |
|
Apprentice
Joined: 16 May 2001
Posts: 42
Location: TSYS - Columbus, GA
|
I am trying to find out how to set these parms under Unix. I am an old mainframer, and I have a customer that needs to set these parameters on their side due to TCP issues. Where do I need to tell him to look, or what do I need to tell him to do?
TIA
_________________
Glen Shubert
Associate Director
MQSeries Technical Support
TSYS |
|
| Back to top |
|
 |
| emileke |
| Posted: Thu Aug 23, 2001 3:04 am Post subject: |
|
|
Centurion
Joined: 19 Aug 2001
Posts: 110
Location: South Africa
|
this is to done in the qm.ini
eg;
CHANNELS:
MAXCHANNELS=n ; Maximum number of channels allowed, the
; default value is 100
MAXACTIVECHANNELS=n ; Maximum number of channels allowed to be active at
; any time, the default is the value of MaxChannels
MAXINITIATORS=n ; Maximum number of initiators allowed, the
; default value is 3 (see note (DUP0018))
MQIBINDTYPE=type ; Whether the binding for applications is to be
; "fastpath" or "standard".
;The default is "standard". (see note (DUP0019))
ADOPTNEWMCA=chltype ; Stops previous process if channel fails to start.
; The default is "NO".
ADOPTNEWMCATIMEOUT=n ; Specifies the amount of time that the new
; process should wait for the old process to end.
; The default is 60.
ADOPTNEWMCACHECK= ; Specifies the type checking required.
typecheck ; For FAP1, FAP2, and FAP3, "NAME" and
; "ADDRESS" is the default.
; For FAP4 and later, "NAME",
; "ADDRESS", and "QM" is the
; default.
TCP: ; TCP entries
|
|
| Back to top |
|
|
|
|
|
| |
|
Page 1 of 1 |
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
|
|
|
|
