| |
|
RSS Feed - WebSphere MQ Support
|
RSS Feed - Message Broker Support
|
  |
|
| MQ SSL:The GSKitSSL communications program could not be load |
« View previous topic :: View next topic » |
| Author |
Message
|
| lium |
 Posted: Thu Aug 07, 2003 8:39 am Post subject: MQ SSL:The GSKitSSL communications program could not be load |
 |
|
Disciple
Joined: 17 Jul 2002
Posts: 184
|
I tried to setup SSL between qmgrs AM and CM. If both qmgrs sitting on machine A, they can talk to each other through SSL without any problem.
Then I moved CM to machine B. Then I got error on B as follows:
AMQ6175: The system could not dynamically load the library
/usr/mqm/lib/amqccgsk. The error message was Cannot run a file that does not
have a valid format.. The queue manager will continue without this module.
EXPLANATION:
This message applies to UNIX systems. The dynamically loadable file
/usr/mqm/lib/amqccgsk failed to load correctly due to an internal error. and
the MQ error recording routine has been called.
ACTION:
Check that the file has not been corrupted then use the standard facilities
supplied with your system to record the problem identifier, and to save the
generated output files. Contact your IBM support center. Do not discard these
files until the problem has been resolved.
----- amqxufnx.c : 703 --------------------------------------------------------
08/07/03 12:33:42
AMQ9220: The GSKitSSL communications program could not be loaded.
EXPLANATION:
The attempt to load the GSKitSSL library or procedure 'amqccgsk' failed with
error code 536895861.
ACTION:
Either the library must be installed on the system or the environment changed
to allow the program to locate it.
This problem doesn't happen on machine A. But I don't know why it happens on B for CM.
Any help, I would be greatlly appreciated.
Michael Liu |
|
| Back to top |
|
 |
| harwinderr |
| Posted: Thu Aug 07, 2003 10:09 pm Post subject: |
|
|
Voyager
Joined: 29 Jan 2002
Posts: 90
|
Which platform are you on??
Normally, the amqccgsk library resides in /opt/mqm/lib on Unix (Solaris, Linux.. not sure about AIX though)
Make sure that amqccgsk is in its default directory.
Later,
HR |
|
| Back to top |
|
|
| lium |
| Posted: Fri Aug 08, 2003 9:51 am Post subject: |
|
|
Disciple
Joined: 17 Jul 2002
Posts: 184
|
Hi, HR,
I found the machine B doesn't meet the prequisite of C and C++ runtime. So I am going to upgrade the AIX operating system and C and C++ runtime environment.
Thx anyway |
|
| Back to top |
|
|
|
|
|
| |
|
Page 1 of 1 |
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
|
|
|
|
