MQSeries.net :: View topic

ramaprasad · Posted: Sun Apr 05, 2009 10:36 pm Post subject:

Kanwar,

Start the installation from scratch (refer "installation instructions" in 'readme file'). Following are the commands:

#pwd (should be '/')
#swinstall -x mount_all_filesystems=false -x allow_incompatible=true -s <absolute_path_of_installation_file> (if MQSERIES requires reboot after installation, then include in the above command '-x auto_reboot=true'. Note: The server will reboot immediately after the installation without any message)

Once above is successful (you can use #swverify -x mount_all_filesystems=false MQSERIES to verify if the installation was successful), run config command to configure the installed component:

#swconfig MQSERIES

If any of commands throw syntax error, refer corres. man page to use proper syntax.

Hope this helps.

Regards,
Ram.