| Author |
Message
|
| Missam |
 Posted: Fri Jan 16, 2004 12:16 pm Post subject: problem when deploying |
 |
|
Chevalier
Joined: 16 Oct 2003
Posts: 424
|
We are getting the following errors when trying to deploy:
BIP5145E: Error setting up runtime dictionary resource using message set identifier 'xyz'.
An error was detected when trying to deploy message set. Use the Control Center to match the message set Identifier : xyz, to a message set name.
Check that you have a valid broker installation. If the problem persists, contact your IBM support center.
Any ideas? We tried stopping/starting broker and config mgr. We removed the message sets its complaining about did a complete deploy on the execution group, then added it back and did a complete deploy and still get the same error.
Any help is appreciated
Thanx
Sam |
|
| Back to top |
|
 |
| skn |
| Posted: Fri Jan 16, 2004 2:24 pm Post subject: |
|
|
Centurion
Joined: 21 May 2003
Posts: 112
Location: Dallas
|
| Are there anyother accompanying error messages.It looks like a database issue.Check the database logs to see if there are any flags raised in there. |
|
| Back to top |
|
|
| Missam |
| Posted: Sat Jan 17, 2004 4:07 pm Post subject: |
|
|
Chevalier
Joined: 16 Oct 2003
Posts: 424
|
| Yep i thought it might be a database problem.but one of our colleague tried removing all message sets and did a complete deployment and again added each one and did a delta.they started working fine. |
|
| Back to top |
|
|
| wooda |
| Posted: Mon Jan 19, 2004 4:32 am Post subject: |
|
|
Master
Joined: 21 Nov 2003
Posts: 265
Location: UK
|
| What version of WMQI are you running ? |
|
| Back to top |
|
|
| Missam |
| Posted: Fri Jan 23, 2004 10:46 am Post subject: |
|
|
Chevalier
Joined: 16 Oct 2003
Posts: 424
|
| We are using mqsi 2.1 CSD 2 |
|
| Back to top |
|
|
|
|
