ASG
IBM
Zystems
Cressida
Icon
Netflexity
 
  MQSeries.net
Search  Search       Tech Exchange      Education      Certifications      Library      Info Center      SupportPacs      LinkedIn  Search  Search                                                                   FAQ  FAQ   Usergroups  Usergroups
 
Register  ::  Log in Log in to check your private messages
 
RSS Feed - WebSphere MQ Support RSS Feed - Message Broker Support

MQSeries.net Forum Index » IBM MQ File Transfer Edition » Channel Problem

Post new topic  Reply to topic
 Channel Problem « View previous topic :: View next topic » 
Author Message
nizar
PostPosted: Wed Apr 07, 2010 4:09 am    Post subject: Channel Problem Reply with quote

Novice

Joined: 24 Feb 2010
Posts: 10
Hello everybody,
When Working in MQ FTE i've installed and configured it to perform a transfer between two local QMgrs QMCOORD(which is the coordination,agent and command QMGR) and QMTEST (which is supposed to be the remote QMgr in the case of a remote transfer)
but the problem is that i can't ping agents which are in the QMTEST
the steps that i followed are :
1)Creating& starting sender/receiver channels QMCOORD.QMTEST & QMTEST.QMCOORD they're both started!!!
2)creating the agent in the QMTEST with the (ftecreateagent) then i run it in the QMCOORD with the runmqsc QMCOORD < agent_create.mqsc
3)starting the agent with the ftestartagent
"but here is the problem the channel: QMCOORD.QMTEST is retrying "
i list agents and the new agent is there but of course im not able to ping it which is understandable
Back to top
View user's profile Send private message
Mr Butcher
PostPosted: Wed Apr 07, 2010 4:53 am    Post subject: Reply with quote

Padawan

Joined: 23 May 2005
Posts: 1716
Quote:
QMCOORD.QMTEST is retrying


then you should solve that first. look into the sending and receiving AMQERR*.log files to find out about the reason.

if i understand your point 1 ocorrectly then this channel was running before, so it is maybe a problem with your queue configuration in combination with an non defined or non used dead letter queue

so check that SYSTEM.DEAD.LETTER.QUEUE exists and check the DEADQ attribute of your qmgrs too
_________________
Regards, Butcher
Back to top
View user's profile Send private message
Display posts from previous:   
Post new topic  Reply to topic Page 1 of 1

MQSeries.net Forum Index » IBM MQ File Transfer Edition » Channel Problem
Jump to:  



You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
Protected by Anti-Spam ACP
  
 


Theme by Dustin Baccetti
Powered by phpBB © 2001, 2002 phpBB Group

Copyright © MQSeries.net. All rights reserved.